Artiron® DS Mono Preservative-free Sterile Eye Drops: Each ml sterile eye drops contains Sodium Hyaluronate BP 2 mg.
Indications: Dry eye or severe keratoconjunctival epithelial injury.
Dosage and Administration: One drop, 3 times daily or as directed by physicians.
Administration guidelines:
Contraindications: Contraindicated in patients who are hypersensitive to any of the components of this preparation.
Side effects: Transient visual disturbance and eye discharge may occur.
Use in Pregnancy and Lactation: Adequate and well-controlled studies in humans have not been done. It is not known whether it is distributed into breast milk.
Precautions: External use only.
Drug interactions: No data found.
Over dosage: No data found.
Storage: Keep out of reach of children. Store in a dry, well ventilated premises at temperature up to 30°C, away from extraneous odors, contamination and intense light. Do not touch dropper tip to any surface as this may contaminate the solution.
Sodium Hyaluronate is the Sodium salt of Hyaluronic Acid. It is a glycosaminoglycan and long-chain polymer of disaccharide units of Na-glucuronate-N-acetylglucosamine.
Mode of Action:
It moistens, soothes and lubricates the surface of eye.
Dry eye or severe keratoconjunctival epithelial injury.
One drop, 3 times daily or as directed by physicians.
Administration guidelines:
\ Open the sachet pack & take Pull off one single-dose vial Hold the vial upright Tap the top until all liquid out the vial strip from the strip goes to the bottom.
( \ ( Twist off the cap without Tilt your head back and pull one drop into the ) Close your eye and press touching the tip your lower eyelid down lower without the inner corner for one touching the eye minute.
No data found. Over dosage: No data found.
Adequate and well-controlled studies in humans have not been done. It is not known whether it is distributed into breast milk.
External use only.
Keep out of reach of children. Store in a dry, well ventilated premises at temperature up to 30 C, away from extraneous odors, contamination and intense light. Do not touch dropper tip to any surface as this may contaminate the solution.